Camshaft bolt loosening sequence-2005 2. You will need to disconnect the brake lines and unbolt them from the hub. Exploded view of the camshaft and cylinder head assembly-1998 2. Apply liquid gasket maker to the mating surfaces of the cover as shown-3. Install the camshaft into the cylinder head 2. If resistance is less than 5 ohms, replace the sensor.
Temporarily tighten the bolts -A- through -D- in the proper sequence. Install the alternator, power steering pump and accessory drive belt. Keep in mind there are small plates on the back sides of the brake pads where the pistons hit the pad, these can be easily lost and are marked with arrows for direction. Paint alignment marks on the camshafts for installation. Refer to the procedure in this section. Testing methods for this type of are slightly different from what you might be accustomed to as well.
Gradually tighten the cap bolts in two stages, first to 7. Remove the connector bracket attaching bolt. Please refer to the following topic: -Accessory Drive Belts-, -Adjustment. Start the engine and allow it to reach operating temperature. Exhaust camshaft cap bolt loosening sequence-2. Rear cover O-ring sizes and locations-3. Einzelner Sensor P0328 Hohe Signalspannung im Stromkreis des Klopfsensors 1 Bank 1 bzw.
Cylinder head bolt loosening sequence-2. Remove the front camshaft cap bolts equally in small increments in the sequence shown-2001-2004 3. Install the timing belt and camshaft sprockets. To install the camshaft cap and oil flow control solenoid valve, apply a small amount of liquid gasket to the mating surface of the cap. If you have any doubt as to repairs on your vehicle, please contact your technician.
Remove the front camshaft cap bolts equally in small increments in the sequence shown-3. For correct timing belt alignment, rotate the intake camshaft 80 degrees clockwise and the exhaust camshaft 45 degrees counterclockwise. Disconnect the negative battery cable. With the belt installed, check that the automatic belt tension indicator is within the range. Camshaft cap bolt tightening sequence-3. There are two of them on each side; remove them both.
However, the use of such oil additives does not void warranty coverage. Rear cover bolt tightening sequence and torque specifications-2005 3. Tighten the cover bolts in the sequence illustrated to the specifications shown in the illustration. P0066 Subaru Auto Trouble Code P0066 Subaru Auto Trouble Code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission. Clean all gasket material from both mating surfaces. Rear cover bolt tightening sequence and torque specifications-2002-2004 3. Arrange the camshaft caps in the order they were removed.
Refer to the procedure in this section. Move the alternator to increase the tension, or decrease to reduce the belt tension. Continue the installation in the reverse order of the removal procedure. Hold rotor with a vise and remove pulley nut. Using a new gasket, install the rocker covers.
Step 3: bolts 15-22 to 6-9 ft. Bolts 2 and 4, the cylinder head and gasket 3. Apply fluid gasket maker of the of the cylinder heads and valve covers as illustrated. Hatte keine Lust mehr die restlichen noch von Hand einzugeben. Refer to the procedure in this section.